70 Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 1 Thoroughly wash the area around the fuel filter and mounting adapter mating area with a suitable solvent and blow dry with compressed air. 2 Disconnect the water-in-fuel sensor harness connector from the plastic water separator bowl. 3 Using tool J 24783, remove the primary filter. 4 While holding the filter above a suitable container, open the drain valve on the plastic water separator bowl and allow the fuel in the bowl to drain. Dispose of the drained fuel in an environmentally safe manner. 5 Unscrew the plastic separator bowl from the bottom of the spin-on primary filter cartridge.
6 Apply a thin film of clean engine oil to the water separator bowl O-ring on the bottom of the new primary filter cartridge. 7 Install the plastic water separator bowl to the primary filter cartridge, and tighten the bowl by hand 1/4 to 1/2 turn after the bowl contacts the O-ring. 8 Apply a thin film of clean engine oil to the sealing gasket of the new filter cartridge. 9 Prime the filter by pouring clean filter fuel through the series of small holes at the top of the filter to the installation fill line. DO NOT prime the filter through the center hole. Use care to avoid dirt entering the center hole of the filter.
10 Install the new filter and tighten an additional 1/2 to 3/4 turn by hand after the gasket contacts the base. 11 Reconnect the water-in-fuel sensor harness connector. 12 Prime the engine as required prior to starting the engine (refer to “Priming the Fuel System MACK MP Engines”, page 72). 13 Start the engine and check for leaks.