Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 71 Secondary Fuel Filter Replacement Procedures At each specified oil and filter change interval, change the secondary fuel filter as follows: Note: Because of ice buildup in the fuel system or fuel waxing which can clog fuel filters, it may be necessary to reduce the time or mileage interval between fuel filter changes during extremely cold weather. To install a new filter: 1 Thoroughly wash the area around the fuel filter and mounting adaptor mating area with a suitable solvent and blow dry with compressed air. 2 Using tool J 24783, remove the old filters.

3 Apply a thin film of clean engine oil to the sealing gasket of the new filters. 4 Prime the filter by pouring clean filtered fuel through the series of small holes at the top of the filter. DO NOT prime the filter through the center hole. Use care to avoid dirt entering the center hole of the filter. 5 Install the new filters and tighten an additional 3/4 to 1 turn by hand after the gasket contacts the base. 6 Prime the engine as required prior to starting the engine (refer to “Priming the Fuel System MACK MP Engines”, page 72). 7 Start the engine and check for leaks.