01 Engine 0165 Exhaust gas treatment 1044-004 Removal ►Disconnect the battery isolating switch of the machine. ►Wait for at least 5 minutes after stopping the diesel engine for the residual pressure in the system to be relieved. ►Allow the diesel engine to cool down. ►Remove the compressed air line (1). ►Remove connector (2). 1 1 2 380 186135-001 2 1 ►Mark urea lines (1) to (3) and pinch off with special tool (I). ►Remove urea intake line (1). ►Remove urea feed line (2). ►Remove urea return line (3).
3 381 186136-001 268 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 Value CCN Remark / designation 8 Inlet coolant lines 9 Outlet coolant lines 10 60 N m Urea pump mounting bolts 11 4 N m Pressure accumulator mounting bolts 12 10 N m Compressed-air connection screw fitting 13 15 N m Urea lines screw fittings – Replace the O-rings every time when assembling. – Coat O-rings slightly with silicon grease. - Use only the specified silicon grease. Tightening torques not specified, see section on tightening torques