01 Engine 0165 Exhaust gas treatment 1044-004 Installation instructions Removal: Remove the urea injection line. Remove the urea inlet line. - Ensure that no urea will drip on electric components. Remove the compressed air line. Disconnect the electric connectors. Installation Install compressed air line. - Check if line union is soiled. Install the urea inlet line. - Check if urea line and line union are soiled. - Shorten the urea line by 2 cm. Install the new urea injection line. Connect the electric connectors. Flushing Use special tool (III). Page 277 ►Screw on test connection at (1) if necessary.
1 409 236418-001 280 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 Value CCN Remark / designation 12 6 Nm Compressed-air tube mounting bolts 13 O-rings – Replace the O-rings every time when assembling. – Coat O-rings slightly with silicon grease. - Use only the specified silicon grease. 13 15 Nm Urea injection line Tightening torques not specified, see section on tightening torques