Safety General Information ►Incorrect polarity of the control units may cause their destruction. ►Always tighten the connections on the injection system to the specified tightening torques. ►When temperatures above 80 °C must be expected, the control units must be removed. ►Use only suitable testing lines for measurements on connectors. ►Observe the manufacturer's regulations for batteries. ►Wear protective clothing when handling batteries. 1044-004 ►Do not tilt the batteries, acid might escape. ►Measure the voltage only with a suitable measuring device. ►Electrolytic gas may form in closed battery boxes.
►Be particularly careful after the engine has run for an extended period and after charging the battery with a charger. ►When disconnecting the batteries, non- disconnected continuous consumers may generate sparks that ignite the gas. ►Vent the battery box sufficiently prior to disconnecting. ►Avoid short-circuits by wrong polarity or placing metal objects on the battery terminals. ►Disconnect batteries when the engine has been shut down and recharge every four weeks. Working on the hydraulic system 64831-003 WARNING Residual oil pressure in hoses / hydraulic components. Serious injury of eyes / of skin. ►Relieve the residual oil pressure in the hydraulic system.
11741-003 NOTICE Serious damage to hydraulic circuit components. ►Before installing hydraulic system components, the entire hydraulic circuit and the hydraulic system components remaining on the machine must be flushed. ►The entire hydraulic system must be free of dirt and foreign objects. ►Replace the hydraulic oil filter. 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014 41