Driving and Operation Emergency parking brake Attention Attention In an emergency, pull up the EPB switch and hold it to use the EPB system to brake the vehicle. Emergency braking can be canceled by simply releasing the EPB switch or depress- ing the accelerator pedal. A slight noise is normal when the parking brake is released or applied. When the power supply is interrupted, the parking brake will not operate. If there is a fault indicator for the electronic parking brake in the combi- nation instrument, it may indicate a fault with the parking brake. Please contact an authorized dealer of Bei- jing Automotive for assistance.
When the vehicle is stationary, the driver's door is opened and the brake pedal is released, the gear is automati- cally switched to P and the electronic parking brake is applied. Attention Under the condition that the car has come to a stop and the EPB motor is running, it is strictly prohibited to press the accelerator pedal if a driving gear is engaged. Otherwise, the vehi- cle will immediately start to move on its own, posing a risk of accidents. Shutdown and parking During emergency braking, the park- ing indicator light in the instrument cluster flashes and the brake light also is ON simultaneously.
Before the vehicle is transported, you can hold the switch for 3s after park- ing to allow the electronic parking brake to clamp again to prevent the vehicle from sliding down during transportation. When the keyless start/stop button is in "RUN" mode and in a stationary state, the electronic parking brake can be applied after the keyless start/stop button is OFF. Turn off the engine and prohibit parking To facilitate vehicle towing, the electronic parking brake switch can be pressed at the same time when the vehicle is OFF, and the electronic parking brake will not be applied to the vehicle. 136 | Driving and Operation