Driving and Operation Lane departure assist system When lane markings are recognized and the vehicle does not deviate, the lane markings are white. When lane markings are recognized and the vehicle deviates, the lane markings are red. The lane departure Prevention (RDP) system detects lane markings using cameras. When the system detects that the vehicle is about to de- viate from the current lane and the driver does not intend to change lanes, it provides steering intervention to assist the driver in keeping the vehicle merging, intersections, traffic jams, etc., this function may fault or not work. Driv- ers are advised to drive with caution.
When a system failure is prompted, please contact a BAIC authorized dealer for processing. When the vehicle tire pressure is too high or too low, but does not reach the the for- tified state, it may cause RDP functions to become unavailable or performance to degrade. This function is only an auxiliary func- tion and cannot replace the driver's control. When using this function, the driver should always pay attention, hold the steering wheel, and be ready to make steering corrections or take over the ve- hicle at any time, otherwise it may cause casualties to people or property.
LDW sensitivity LDW sensitivity refers to the trigger frequency of LDW alarm,And under high sensitivity, there are fewer conditions to suppress the alarm,while under low sensitivity, there are more conditions to suppress the alarm. High sensitivity suppres- sion conditions: The vehicle deviates from the direction and turns on the turn indicator light. ESC or ABS intervention; Crossing the lane line quickly and continu- ously. Curve riding drive. Lane consolidation. Strong braking. Low sensitivity suppression conditions: All high sensitivity suppression conditions. Sharp turn (too high turning rate).
Pressed the accelerator hard Attention This function does not work when the camera is covered by rain, snow, mud, ice, etc. the drivers are asked to drive carefully and keep the camera area clean. When the camera fails to detect the lane markings due to reasons such as road construction, road surface water accu- mulation, road surface cracks, or unclear road markings, the function will not oper- ate. Drivers should exercise caution. This function may fault or not work in environments such as night, rain, snow, fog, shadows, etc. Please drive with cau- tion. When encountering complex working conditions such as lane additions, lane Driving and Operation | 157