Driving and Operation Once the function is enabled, when the light control lever is turned to AUTO and the low beams go on, and the vehicle speed is >40km/ h, the headlights can automatically switch be- tween low beam and high beam based on envi- ronmental conditions. The intelligent high beam auxiliary working indicator light is ON (when the vehicle speed is lower than 20km/h, the sys- tem automatically switches to low beam). When the camera detects vehicles ahead or the environment becomes brighter, this function automatically turns off the high beam and the high beam indicator on the combination instru- ment panel goes off.
When the camera detects that the vehicle ahead has disappeared, the high beam lights are re- stored. Even after this function is turned on, the driver can manually switch the high beam and low beam lights. After the "Follow Me Home" function is activated, it can be activated again within 5 minutes through remote control locking. Attention Intelligent high-beam light assist system The intelligent high-beam light assist system uses a camera to judge the current driving envi- ronment and controls the automatic switching between low beam light and high beam light when the vehicle lighting is activated.
The system can identify whether there are other ve- hicles in the opposite direction or the same di- rection in front, and switch between low beam light and high beam light modes according to the situation. Attention Even after this function is turned on, the driver can manually switch the high beam and low beam lights. When the camera is dirty, blocked, or faulting, the smart high beam function may be unavailable or its performance may be degraded. HMA system is an auxiliary func- tion,which cannot be guaranteed to be applicable to all driving situations. The driver must control and drive the vehicle carefully.
When the vehicle is in a highly dynamic state (such as ABS or ESC activated), light changes will be suppressed. Attention Automatically start and disable high beam Start and close the smart high beam light function When the camera detects that there are no vehi- cles and street lights ahead, this function auto- matically activates the high beam and the high beam working indicator light on the instrument cluster is ON. > Driver Assistance > Lighting As- sistance. The intelligent high beam function can be set to Start and close. Click the vehicle settings button on the center console 176 | Driving and Operation