Park Assistance When entered through the opening con- dition (press the multi-view switch on the steering wheel when the vehicle speed is closing condition (no operation in P gear for 5s). Attention Blind spot monitoring system Introduction to blind spot monitoring system Use of blind spot monitoring system Click the vehicle settings button on the center console > Driver Assistance > Side and Rear Assistance. The blind spot monitoring function can be started and closed. The BSD function can be activated when the vehicle is started, BSD is ON, and the vehicle speed is >12km/h.
The Blind Spot Monitoring System (BSD) uses radar sensors to monitor the blind spots of the exterior rearview mirrors and alert the driver to avoid accidents due to the blind spots of the rearview mirrors during lane changes. When a moving vehicle is detected in the sys- - eration Attention When the system is started, the default screen of the system is front view + multi-view when it is not in R mode, and it can be switched to other views through gear position, turn signal or touch screen operation. When the vehicle is in "R" gear, the default screen is 2D rear view + multi-view. In this view, dynamic (and static) auxiliary lines will be integrated.
When turning the steering wheel, the guideline will calculate the vehicle’s tra- jectory based on the steering angle to assist the driver during parking. for the blind spot monitoring inside the exterior rearview mirror of the corresponding side will be normally on. If the driver is ON the corresponding turn signal at this moment, the indicator - cator When BSD is turned on, any of the following conditions can be met to exit: Vehicle speed BSD or LCA functionality is OFF. Turn off the lane change assist function. out a warning to alert the driver of the presence of a moving vehicle in the blind spot of the rearview mirror. 196 | Park Assistance