. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the 1. If the work diagram on speed, retract 3. Within 15 4. Open the door of the pump room on the right side of the between the H and L lines. 3 - 57 REMARK If breather hole (5 ) on the cap is clogged, the pre ssure in the tank will drop and fuel will not flow. m time to time. Clean the hole fro o down before starting the work.
When removing t he oil filler cap, turn it slowly to rel quipment is not in the positio e right, start the engine, run th n shown in the e engine at low t the arm and bucket cylinder rods fully, then m, set the bucket teeth in contact with the ground, engine. ing switch to the ON position. conds after stopping the engine, move each conds after stopping the engi for work equipment and travel) to the full stroke s to release the internal pressu re. check sight gauge (G). The oi l level should be NOTICE Do not add oil abov e the H line. This will damage the h ydraulic circuit or cause the oil to spu rt out.
If oil has been added drain plug (P) unde above the H level, stop the upper st r the hydraulic tank will be betwee ructure so that the n both tracks, and stop the engine and wait for the hydraulic oil to cool do wn, then drain the excess oil from drai n plug (P).