Komatsu — AFTER STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS AFTER STARTING ENGINE WARNING Warming-up Operation 3 - 73 When a m achine trouble suc h as emergency stop an d abnormal movemen t occurs, tur n the engine starting swi tch to the OFF position. If t he wo rk equipment is op erated without w arming the machin e up sufficiently, the r esponse of the work equ ipment to the moveme nt of the control lev er will be slow, an d the w ork equipment m ay n ot move as th e operator desires, so al ways carry out th e warming-up operation.

P articularly in col d areas, be sur e to carr y out the warming- NOTICE When the hydraulic oil is at a low temperatur e, do no t carry out o peration s or move the levers suddenly. Alway s carry out the warm-up operation. This wil l help to extend t he mach ine life . operation is completed. Do not s uddenly accelerate the engine befor e the wa rm-up operatio n is c Do not ru n the e ngine at low idle or high idle con-tinuously for more than 20 minutes. This will cause leakage of oil from the turbocha rger oil supply pipi ng. ngine at idle, apply a load from time to time or run the engine at a mid-range speed.

If i t is ne cessary to run the e ngine at idle, ap ply a loa d from time to t ime o r run the eng ine at a mid-range spee After starti ng the engine, do not immediatel y start o perations perform th e following opera tions and chec 1. T urn fu el control dial (1 ) to the center positio n between I a DLE a nd HIGH IDLE a nd run the engi ne at m edium speed f bout 5 minutes with no