Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT AND INVERSION WARNING Replacement 1. Place the bucket in contact with a flat surface. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. Align the arm with holes (1) of the replacement bucket and the link with holes (2), then insert grease-coated pins (A) and (B) into hole (1) and hole (2) respectively. 4. Install the stopper bolts and nuts for each pin, then grease the pin. 3 - 96 When pins are knocked in with a hammer, pieces of metal may fly and cause serious injury.

When carrying out this operatio n, always wear goggles, hard hat, gloves, and other protective eq When the bucket is removed, pl If pins are hit with a strong force , there is a hazard that the pin may fly ou t and injure people in the s urrounding area. Ma ke sure that there is no one in the surro unding area before starting the operation. When removing the pins, do not stand behind the bucket. In addition, be extremely careful not to pu t your foot under the bucket while standing at the side for th e work. s, be extremely careful not to get your fingers caught. e pin holes when aligning the holes.

When removing or inserting pin s, be extremely careful not to get your f Never insert your fingers into th Stop the machine on a firm and flat surface and do the work. When performing joint work, appoint a lead and follow that person's instructions and signals. REMARK When removing the pins, pla contact with the ground. ce the bucket so that it is in light ly to the ground, the resistance will If the bucket is lowered strong be increased and it will be diffi cult to remove the pins. NOTICE After removing the pins, make sure that mud or sand does not get on them. Dust seals are fitted at both ends of the bushings, be careful not to damage them. REMARK reverse order to removal.

Carry out installation in the When installing the bucket, the O-rings are easily damaged, fit the O-rings on the boss diagram.When knocking th regular groove. of the arm end as shown in the e pin, move the O-ring down to the