Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS Inversion WARNING 1. Place the bucket in contact with a flat surface. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. Turn the removed bucket. After turning the bucket, align the arm with link mounting hole (1), then align the link with arm mounting hole (2) and install. 4. Align the arm with holes (1) of the replacement bucket and the link with holes (2), then insert grease-coated pins (A) and (B) into hole (1) and hole (2) respectively. 5. Install the stopper bolts and nuts for each pin, then grease the pin.

3 - 97 When reversing a bucket, there is the danger that the bucket tooth tip overruns the normal trajectory and interferes with the cab, thus causing a serious trouble. Pay good attention to the work when reversing a bucket so that the bucket and the cab may no t interfere with each other. REMARK When removing the pins, plac contact with the ground. e the bucket so that it is in light y to the ground, the resistance will ult to remove the pins. If the bucket is lowered strongl be increased and it will be diffic NOTICE After removing the pins, make sure that mud or sand does not get on them. Dust seals are fitted at both ends of the bushings, be careful not to damage them.

REMARK hole (1) of the arm and bucket. Install the O-ring into retaining When installing the bucket, the O-rings are easily damaged, so fit the O-rings on the boss of the a the right. When knocking in the rm end as shown in the diagram on pins, move the O-ring down to the regular groove.