. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 23 3. enough to make it possible to touch the radiat or cap surface by hand, then turn radiator cap (3) slowly unt se the pressure. il it contacts the stopper to relea 4. Following this, p ush radiator cap (3), turn it un til it contacts the stopper, then re move it. 5. Open drain valv e (4) at the bottom of the radia tor and drain the water. Remove drain pl ug (5) in the cylinder block an d drain the water. 6. After draining th e water, close drain valve (4) and tighten drain plug (5), then fill with city water. 7. When the radiat or is full, start the engine, and run it at low idle.
Keep the engin e running at low idle for 10 water temperatu re reaches more than 90°C ( 8. Stop the engine plug (5) to drain 9. Close drain valv e (4). Wind seal tapes onto d rain plug (5), the 10. Install covers (1 11. Add coolant mix ed with antifreeze until it ove rflows from the water Decide the prop ortions of antifreeze and wate r according to the table for the mixing rat e of water and antifreeze. 12. To bleed the air from the cooling system, run the engine at low idle for 5 minutes, and for a further 5 minutes at high idle. (When doing this, leave the radiato 13.
Drain the coolan t inside sub-tank (6), clean sub-tank, then fil l again with coolant to a point midway between the FULL and L OW marks. 14. Stop the engine , wait for approx. 3 minutes, then add coolant until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coolant if necessary. until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coo lant if necessary.