. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (VERTICAL PIN TYPE) WARNING rubber pin locks (3) with the following used, the teeth may come off the bucket. 4 - 28 It is dangerous if th e work equipment moves by mistake when th e teeth are being replaced. Set the work equip ment in a stable condition, th en stop the engi ne and set the lock lever s ecurely to the LOCK position . The pins can be kn ocked out only with strong for ce, so there is a hazard that the pin may fly area. out. Check that there is no one in the surrounding There is a hazard th at fragments will fly during th e replacement w ork, so always wear protec tive equipment like safety gl asses and glove s.
Replace the bucket teeth before the adapter starts to wear. 1. To make it pos sible to knock out the pin of tooth (1), s bottom surface of the bucket on a block, check that the work equipment is in a stable condition, then se t the lock lever to the LOCK position. Set so that theb ottom face of the bucket i 2. Use a hammer and drift to knock out lock pin (2). (If the drift is set against rubb er pin lock (3) when it is hi t, the rubber pi n lock may break. Set it against the back of the 3. After removing l ock pin (2) and rubber pin l ock (3), check them. I f l ock pins (2) and Replace them with The lock pin is to efects are