. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE come out. 4 - 29 The rubber of the rub ber pin lock is torn, and the st eel balls m ay The steel balls are bu ried when they are pressed 4. Clean the surface o f adapter (4) and remove the soil with a knife. 5. Use your hand or a hammer to push rubber pin lo ck (3) into the hole of the adapter. When doing this, be careful that the rubber pin loc k (3) does not fly out from the ada 6. Clean the inside of t eeth (1), then install it to ada pter (4). If there i s mud a ffixed to it or if ther e are protrusions the teeth (1) will not enter the adapter properly, a nd there will not be prop er contact at the m 7.
Fit tooth (1) to adapt er (4), and confirm that when the pointe r is pressed strongly, th e rear face of the hole for t he pin of the teeth (1) is at the sa me level as the rear face of th e hole for the pin of the adapter (4 If the rear face of th e hole for the pin of teeth (1) is protruding to the front from the rear face of the pin hole for a dapter (4), do not try to knock the There is something preventing teeth (1) from ent ering adapter (4) fully, so remov adapter (4) fully, kn