Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 30 8. Inser t lock pin (2) in the hole of t he t eeth (1) a nd hit it unti l its top is th e same level as the surfac e of teet h (1). 9. After replacing a bucket tooth, always c hec k the following 1) A fter the loc k pin (2) has be en k nocked in completely, heck that it is secured by the teeth (1) and s urface 2) L ightly hit loc k pin (2) in the reverse direction from w hich it as hit in. 3) L ightly hit the tip of the teeth (1) from above an d below, and it its sides f rom right and l eft.

4) C onfirm that rubber pin loc k (3) and lock pin ( 2) are se t as hown in the The life can be lengthened down so that it will w ear evenly Replace the rubber p in lock and locking pin a t the sam e time as replacing the teeth. This mak es it possible t o prevent the teeth from falling the frequency of i ts replacement ca