Komatsu — REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) WARNING 4 - 31 It is dangerous if the work equipment moves by mist ake when the teeth are being replaced. Set the work equipm ent in a stable condition, then s top the engine and set the lock lever sec urely to the LOCK position. The pins can be knoc ked out only with strong force, so there is a hazard that the pin may fly o area. ut. Check that there is no one in the surrounding There is a hazard that fragments will fly during the re placement wor k, so always wear protecti ve equipment like safety glasse s and gloves. Replace the bucket t eeth before the adapter star ts to wear. out, put a b e that the 1. 1.

In order to enabl under the buck e tooth pin (1) to be pulled lock et bottom and make sur work equipment rests o n it securely. Then move th e lock lever t o the LOCK position. In that case ensure that the bucket is lev el on the block. 2. Place a bar on th e head of pin (1), hit the bar with a hamm er to knock out the pin REMARK If the bucket teeth cannot be safely removed by this mothod, I have your Komats u distributor replace the bu cket teeth. 3. Clean the mount ing face. Fit a new tooth (2 ) in the adapter, push in pin (1) pa rtially by hand, then lock it with a hamm er to install the tooth to the bucket.