Komatsu — CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL

. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 46 EVERY 250 HOURS MAINTENANCE Maintenance for eve ry 50 hours service shou ld be carrie d ou t at the The oil is at high te mperature immediately after the machine has b een operated. Wait for the oil to cool down before starting the operation. If there is still press ure remaining inside the ca se, the oil or p lug may fly Loosen the plug slo wly to release the pressure. Prepare a contain Prepare a hexag 1. Set so that plug (F) is at the top, with plug (F) and plug (P the ground. prependicular to 2.

Using a hexago nal wrench, remove plug ( F) and chec k tha t the oil level is within a range from the bottom of the plug hole to a point 10 mm (0. 4 in) below it. 3. If the oil level is low, add oil through the h ole of plug (F). Add oil until oil overfl ows from the hole of plug 4. After checking, i Large-capacity Fin al Drive (G) is at the top, with plug (G) and plug (P the ground. (If 1. 2. 3. 4. 1. perpendicular to 2. Remove plug (G ) with a hexagonal wrenc h. Oil level shouldbe near the bottom of the plug hole (G). 3. If the oil level is low, use a hexagonal wr ench to remove plug (F), then add oil through the hole of plug (F).

Add oil unti l the oil overflows fro m the hole in plug (G). F) and (G). 4. After checking t he oil level, install plugs (