. MAINTENANCE MAINTENANCE PROCEDURE CHECK LEVEL OF BATTERY ELECTROLYTE Perform this check before operating the machine. WARNING the NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. 3. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (2) and add distilled water to the U.L line. 4. After adding distilled water, tighten cap (2) securely. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to the U.L. line.
Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker. 4 - 47 Do not use the battery if the battery e lectrolyte level is below the LOWER LEVEL line. This will acc elerate deterioration of inside of the battery and reduce the service life of the battery. In addition, it may cause an explosi on. near the battery. The battery generates flammable gas and there is danger of explosion, do not bring fire or sparks Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with a large amo unt of water and consu doctor.
When adding distilled water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If ak and cause damage to the paint surface or corrode other parts. electrolyte level is too high, it may le ak and cause damage to the paint surface or corrode other pa Inspect the battery electrolyte level at least once a month and follow the basic safety proc edures given below. When Checking Electrolyte Level fr om Side of Battery yte level from the side of the battery, check as follows. d remove sheet (1) installed above the battery. ea around the electrolyte level ctrolyte level is between the ER LEVEL (L.L.) lines.
ry cloth, static electricity may If it is possible to check the electrol yte level from the side of the battery, check as follows. 1. Open the battery room door an 2. Use a wet cloth to clean the ar lines and check that the ele UPPER LEVEL (U.L.) and LOW If the battery is wiped with a d cause a fire or explosion. . Open the battery room door an