Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. REMARK Add Oil (PAGE 3-55)". 4 - 53 Oil pan refill amount: 11 lit Prepare a filter wrench 1. Remove undercover (1) a t the bottom of the machine, th en set the container under dra in valve (P) on the left side of the machine to catch the oil. 2. Loosen drain plug (P) an d drain the oil. Be careful not to get oil on yourself. Tighten drain plug (P). 3. 4.

Open the pump room on using the filter wrench, remove it. the right side of the machine , then turn filter cartridge (2) to the left to 5. Clean the filter holder, fill the new filter cartridge with cle an oil, coat the thread and pack ing portion of the new filter car tridge with oil (or coat thinly wit h grease), then install. Check that there is no old pa cking stuck to the filter holder. If there is any old packing stuck to th e filter, it will cause leakage of 6. When installing, tighten u ntil the packing surface contac ts the filter holder, then tighten a further 3/4 turn. cartridge, add oil through oil filler (F) 7.

After replacing the filter until the oil level is betwe en the H and L marks on the di pstick (G). Run the engine at idle fo r a short time, then stop the engine, 8. ngine, and check that the oil leve dipstick. For details, see l is between the H and L marks "Check Oil Level in Engine Oi on the l Pan,