. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING 4 - 54 The engine is at high t emperature immediately after the m achine has b een operated. Wait for the eng ine to cool down before replacing the filter. arks near the fuel. Do not bring fire or sp Prepare a filter wrench and a container to catch the fu el. artridge. 1. Set the container t 2. Using a filter wren on remove it. 3. Clean the filter hol Coat the packing s cartridge into the fi 4. When installing, sc with sealing surfa turn. 1. Set the container t o catch the fuel under the filter c 2. Using a filter wren ch, turn filter cartridge (1) count erclockwise 3. Clean the filter hol der.
Fill a new filter cartridge with clean fuel. urface with engine oil. Then ins tall the new lter holder. 4. When installing, sc rew in cartridge until seal come s in contact ce, then tighten approx. an additional 1/2 NOTICE If the filter cartridge is tig htened excessively, the packing will be damaged and fuel will leak. If the fil ter cartridge is too loose, fuel will al so leak from the packing, so always ti ghten to the correct amount. 5. After replacing the fuel filter element, bleed air. GE 4-54)". For details of the p rocedure, see "Air Bleeding (PA GE 4-54)". 6. After replacement of the filter cartridge, start the en gine and check it f or possible oil seepa ge from the filter seal.
If oil leaks, check cartridge again in whether some fore If any of the cases the filter cartridge tightening con dition and r etighten it. Should oil still l eak, remove the filter the sequence of Item 1 and 2 ign material has got caught. above, and check the packing surface for any damage or is noticed, replace the packing w ith new on e and r epeat the steps in Ite m 3 through 6 above. Air Bleeding 1. Fill the fuel tank wit highest position). 2. Loosen air bleed p 3. Loosen the knob o until no more bubb bleed plug (1). 4. Tighten joint bolt ( 1. Fill the fuel tank wit h fuel (to the position where the fl oat is at the lug (1) and joint bolt (2). 2. Loosen air bleed p 3.
Loosen the knob o f feed pump (3), then pump it u p and down les come out with the fuel from th e hole of air 2) and air bleed plug (1). 4. Tighten joint bolt ( REMARK Use the same proced ure to operate the feed pump an d bleed the airif the machine runs out of fuel.