Komatsu — CHANGE OIL IN SWING MACHINERY CASE

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN SWING MACHINERY CASE WARNING kgf · m, 32.5 to 68.7 lbft) 4 - 59 EVERY 1000 HOURS Maintenance for every 50, 100, 250 and 500 hours serv ice should be carried out at the The parts and oil are at high te mperature after the engine is sto pped, and may cause serious burn s. Wait for the temperatu re to go d own before starting the op R efill capacity: 2.5 liters 1. Swing the upper structu re so that drain plug (P) is be tween the left and right tracks. Set an oil container un der drain valve (P) at the bottom of the machine. Remove drain plug (P) at the bottom of the machine, drain the oil, then tighten the dra Tightening torque for d 4.

Remove dipstick (G) a nd the cap of oil filler (F), then add the from oil filler (F). ipstick with a cloth. into filler pipe (F), then remove it. specified amount of oil 5. Wipe off the oil on the d 6. Fully insert dipstick (G) into filler pipe (F), then remo 7. The oil level should be between the H and L marks o n oil level gauge (G). If the oil lev el is below the L mark, add o il through oil filler port (F). mark, drain the excess oil from drain e oil level again. 8. If the oil is above the H plug (P), then check th