. MAINTENANCE MAINTENANCE PROCEDURE CHECK PTO GEAR CASE, ADD OIL WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil 3. Remove oil inspection plug (G) and check that the oil is near the bottom of the plug hole. inspection plug (G). 4 - 62 EVERY 2000 HOURS MAINTENANCE Maintenance for every 50, 100, 250, 500 and 1000 ho urs service should be carried out at temperature to go down before perf orming this 1. Swing the upper structure so that the PT O gear ca se is in the middle between the left Stop the engine and set the lock leve r to t he LOCK position. 2. Remove undercover (1) at th e bottom of t he mach 4.
If the oil le vel is low, open the pump room d oor on th e right side chine, remove the plug from oil f iller (F), and ad d oil. til the oil level is cl ose to the bottom of th e hole of oil 5. Install oil inspection plug (G) and the plug of oil fille 6. Install cov