Komatsu — CHECK PLAY TURBOCHARGER ROTOR

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING cause burns. Wait for the 1. Remove the cover at the top of the hydraulic tank. 2. Remove the cap from oil filler (F), and release the internal pressure. 3. Loosen 3 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so hold the cover down when removing the bolts. 4. After removing spring (2) and valve (3), take out element (4). 5. Clean the removed parts in diesel oil. 6. Install the new element in the place where old element (4) was installed. 7. Set valve (3) and spring (2) on top of the element. 8.

Set cover (1) in position, push it down by hand, and install the cover with the mouning bolts. 9. Install the oil filler cap, then install the cover at the top of the hydraulic tank. 10. To bleed the air, start the engine according to "STARTING ENGINE (PAGE 3-68)" and run the engine at low idle for 10 minutes. 11. Stop the engine. 12. Check for oil leakage and wipe off any spilled oil. CHECK ALL TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have the tightening portions checked. CHECK PLAY TURBOCHARGER ROTOR Contact your Komatsu distributor to have the rotor play checked.

4 - 61 temperature to go down before s When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. NOTICE f the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket er than during n ucket operations. For details, see "MA maintenance. INTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-15)" when carrying out carrying REMARK Wait for at least 5 minutes after stopping the eigine to eliminate bubbles in the oil inside