COLD WEATHER STARTING AND STARTING AID SYSTEMS Table 16-1 Common Battery Heaters 16.3.1.8 Heating Engine Compartment Another means of heating an engine is to use an external fuel fired air heater, which blows hot air onto the engine oil pan, air inlet, and batteries. To make this system effective, the engine compartment should be totally protected from the effects of outside wind, which will reduce the efficiency of the heater. Care must be taken not to damage any electrical engine component or wiring. 16.3.2 STARTING PROCEDURES The engine starting procedure may change with the use any starting aid. Please review the recommendations with each starting aid.
Changes to starting procedures because of cold weather may include: A specific order of operation to achieve an engine start. On electronically controlled engines this may include: Automatic changes made by MCM to the fuel timing Automatic operation of the Ether Start Automatic setting and adjustment of high idle speed A time delay for air intake heater operation. 16-12 All information subject to change without notice.
DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION Heater Type Description Insulated Box Type This unit can be fabricated from heavy gage sheet metal with rigid foam insulation applied to the outer surfaces, or it may be of double-walled formed-in-place urethane construction. Plate Type This unit employs a metal sheathed tubular element of "U" shaped sandwiched between heavy gage sheet metal plates and equipped with an integral control thermostat. This unit is mounted directly under the battery. Mat Type This unit is comprised of a heavy gage rubber material, incorporating a serpentine pattern resistance wire element imbedded in the center area of the material.
The unit relies on low watt density radiant energy to heat the battery and is intended to be mounted directly under the battery. Strip Type Commercially available strip heaters can be employed for heating batteries. These are generally of higher watt densities. Care must be exercised to ensure that they do not come into direct contact with the battery casing. It is advisable to mount these units on the inside wall of the battery box. Blanket Type Flexible construction comprised of a heavy aluminum foil element assembly of low watt density, complete with fiberglass insulation on one side, enclosed in a heavy gage acid-resistant plastic sheath.
The unit is provided with ties and is intended to be installed tightly around the sides of the battery or batteries. This unit has the advantage of integral insulation. Air and Coolant Types Other sources of battery heat in addition to electric heaters are forced hot air or coolant. These either circulate hot air through the battery box or the use of warm coolant circulated through passages in the battery box.