ACCESSORY DRIVE SYSTEM 17.1 ACCESSORY DRIVES There are no accessory drives Rear Engine Power Take-Off (REPTO) located on the flywheel housing for the DD Platform engine at this time. The Accessory Drives Front Engine Power Take-off (FEPTO) located on the front cover housing are listed in Table 1–1 and Table 1–2 below.
Table 17-1 DD Platform Accessory Drives on Crankshaft (Non-Gear Driven) * An adaptor is necessary for adaptation of the PTO Front Crankshaft Accessory Drive to adapt to DD Platform Vibration Damper Pulley Maximum combined PTO of accessory drive plus front drive not to exceed 25 hp continuous, 30 hp intermittent @ rated engine speed Table 17-2 DD Platform Accessory Drives on Crankshaft (Gear Driven) 17.2 GEARTRAIN The geartrain for a DD Platform engine is located at the rear of the engine. The geartrain consists of intake and exhaust camshaft gears, idler gears 1-5, crankshaft gear, oil pump gear, fuel pump gear, air compressor gear, and turbocompound gear.
17-2 All information subject to change without notice.
DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION Accessory/Location Front Cover Housing Drive Ratio Rotation (as viewed from front of engine) Drive Type (SAE Flange) Comments Vibration Damper Pulley off Front Crankshaft -- CW 8 groove Poly-V w/10 groove Poly-V Z53700903 Z53700904 Z53700908 Accessory / Location Front Cover Housing Drive Ratio Rotation (as viewed from front of engine) Shaft Coupling (SAE) Drive type (SAE Flanges) Capacity in lb·ft @ rpm Comments PTO Front Crankshaft — CW Spicer 1350 4 groove pulley 224 lb·ft (77hp) @ 1800rpm PTO Front Crankshaft — CW Spicer 1310 4 groove pulley 120 lb·ft (41hp) @ 1800rpm PTO Front Crankshaft — CW Spicer 1350 10 groove pulley 224 lb·ft (77hp) @ 1800rpm