MAN — MAN DD13 DD15 Engine Application Installation Manual

DD PLATFORM APPLICATION AND INSTALLATION MANUAL 1. Waterpump Pulley 6. Tensioner 2. Idler Pulley 7. Tensioner 3. Crank 8. Tensioner 4. Generator 9. Cooling Fan 5. Freon Compressor 10. Idler Figure 17-3 DD Platform DRIVETRAIN 17.4 BENDING MOMENT The bending moment ( M ) on the front of the crank equals force ( F ) times distance ( L ) from the front face of the block. The force is usually caused by belt tension on the crankshaft pulleys . The maximum allowable bending moment depends upon the angled direction that the force around the crank (as referenced from the front face of the engine) is to be applied.

For multiple hub loads, take the vectorial sum of the maximum allowable bending moments at each angled direction of force to determine the total maximum allowable bending moment. The front crankshaft maximum allowable polar bending moment diagram is in ft·lb and referenced from the front face of the block. All information subject to change without notice. 17-5 DDC-SVC-MAN-0073 Copyright © 2009 DETROIT DIESEL CORPORATION