PACCAR Inc. W900, T660, T800, C500, 963 — Sleeper Heater - A/C Controls (option)

HEATING AND AIR CONDITIONING 2.) Turn the Air Flow Control Dial Sleeper Heater - A/C Controls (option) to Defrost Vents. Fresh air and air conditioning are automatically turned ON. NOTE 3.) Adjust the Temperature Control Dial clockwise to full heat. On the Cab Control Unit, the Sleeper Enable Switch must be pressed to turn ON power to the Sleeper Con- trol Unit. In addition, if air condition- ing is requested in the sleeper, the Air Conditioner Switch on the Cab Control Unit will be turned ON and the fan in the Cab Heater and Air Conditioning Unit will be turned ON low (if it was OFF), automatically.

Aerocab & Studio Sleeper Controls CAUTION 3 During extreme cold weather, do not blow hot defroster air onto cold wind- shields. This could crack the glass. Turn the Air Flow Control Dial to De- frost and adjust the fan speed ac- cordingly while the engine warms. If the engine is already warm, move the Temperature Control Dial to cool, then gradually increase the temper- ature when you see that the wind- shield is starting to warm up. Failure to comply may result in equipment damage. Fan Control (1) Turning this dial controls fan speed. Heat & A/C Control (2) (Aerocab & Studio): Allows you to select between, Max Heat , Max A/C , and Auto Heat - A/C . Max Heat:

Fully opens the valve that allows hot engine coolant to flow through the heater core. Modular Sleeper Controls Max A/C: Completely closes the engine coolant valve. (02/14) Y53-1203-1D1 3-19