. OPERATION TROUBLESHOOTING TROUBLESHOOTING AFTER RUNNING OUT OF FUEL the engine runs out of fuel, add fuel to the fuel tank, then bleed the air from the fuel system before starting the engine. PROCEDURE FOR BLEEDING AIR CAUTION (2). 3 - 127 I f t The fuel injection pu mp and nozzle of this en gine consist of more p recise parts than the conventi onal ones. If foreign matter enters them, it can c ause a trouble. Accordin gly, if dust st icks to t he fue l system, wash it off with Be careful when ope ning the air bleed plug in the fuel filte r head. T he internal pressure may caus 1. Fill the fuel tank with fuel. ing plug (1) at the fuel main filter head.
e plug at the filter head of the fuel prefilter. s not bled. 2. Loosen air bleed Do not loosen th is loosened, air i 3. Loosen wing nu Pump lever (4) until bubbles sto t (3) holding lever (4) of priming pump up and down to carry out priming. Conti p coming out with the fuel from the hole for bleed plug (1). ing plug (1) and then tighten wing bolt (3 ) securely to lock lever (4). que for air bleeding plug {0.8 to 1kgm} que for wing screw {0.7 to 1.3kgm, 5.1 to 9.4 lbft} 4. Tighten air bleed priming pump (2 Tightening tor 7.8 to 9.8Nm Tightening tor 6.9 to 12.7Nm priming pump (2 ) securely to lock lever Tightening tor que for air bleeding plu Tightening tor {0.7 to 1.3kgm, 5.1 to 5.
Turn the key in t he starting switch to th e START p osition start the engine. s, do not keep the starting motor rota more than 20 seconds. s not start, wait for at least 2 minutes bef When doing thi continuously for more than 20 seconds If the engine doe s not start, wait for at trying again. Ca rry out this operation a maximum of 4 tim 6. If the engine doe s not start, repeat the procedure f rom ste