. OPERATION TROUBLESHOOTING IF TRANSMISSION HAS TROUBLE at a safe place. set the lever is operated. In this case, perform the following procedure. 1) When the While the emergency escape function is actuated, the machine monitor shift indicator displays "E" and the transmission shift range in turn. 3 - 128 If the transmission ha s any trouble, operate the m achine ac to the following proc 1. Use the foot brak e to reduce the speed and stop the m 2. Set the gear shi itch to PARKING position. 3. In some trouble modes, the gear is not shift ed even if t arting switch is at ON po sition or th e engine is st arted, disconnect (p ull out) emergency ) (No.
A1 (female), A1 (mal e), white 1 -pin connector), then connect (insert ng brake switch to TRAVE L position. gear shift lever to move the machine t o a safe place w ithout depressing the accelerator pedal. If the gear shift lever i s operated with the acceler ator pedal d epressed, the e mergency escape fu nction will not work. In addition, the emer gency escape function ma y not work for some failure codes. METHOD OF LOWERING DUMP BODY IN EMERGENCY When the dump body needs to be lowered to the seat while the engine cannot be started for some trouble, perform the following procedure. 1. Remove cover (2) from the rear of hydraulic tank (1). 2. Loosen locknut (4) of manual lower valve (3). 3.
Turn grip (5) of valve (3) counterclockwise. The oil in the hoist cylinder is drained into the hydraulic tank and the dump body lowers. 4. Tighten grip (5) and locknut (4) and install cover (2). If the dump body does not go down even when the above method is used, consult your Komatsu distributor. When the dump bod engine cannot be st procedure. 1. Remove cover (2 ) from the rear of hydraulic 2. Loosen locknut ( 3. Turn grip (5) of v 4) of manual lower valve (3 alve (3) counterclockwise. 4. Tighten grip (5) a nd locknut (4) and install c