Saw - 88 RT40 Operator’s Manual p Operating Tips Operating Tips Work slowly and carefully. Wash bits and mounting blocks with high pressure water before parking unit overnight. Before operating saw, check bits for free rotation. Tap bits lightly with a hammer and turn by hand. If bits are stuck, remove and clean packed soil from bit block. For best results, use retaining clip loading and removing tool and a knock-out bar included with saw to remove and reinsert bits. Carbide bits are recommended for cutting abrasive material, such as sandstone or frozen sands or gravels. Saw use is not recommended for soft, wet, or sticky soil conditions.
Lower saw into softer material then move into harder or abrasive material. For example, lower saw into dirt at shoulder before cutting across road. If a curved trench must be cut, make a series of straight cuts. CMW