Ditch Witch / Charles Machine Works RT40 — Drill Rod and Equipment

RT40 Operator’s Manual Drill - 97 Prepare Jobsite and Equipment p Prepare Jobsite and Equipment Approach Trench (1) 1. Mark path where you intend to drill. 2. Dig an approach trench (1) along the intended bore path. IMPORTANT: The approach trench should be at least: deep enough for pipe to lay flat and enter soil at correct angle 20’ (6 m) long 4” (100 mm) wide Target Trench (2) 1. Select a completion point for the drilling project. 2. Dig a target trench (2) across the anticipated completion point. IMPORTANT: The actual length of the target trench depends on soil conditions and length of pipe sections. Make it deep enough for drill bit to enter slightly above the trench floor.

Drill Rod and Equipment 1. Assemble at least 20’ (6 m), but not more than 30’ (9 m), of drill rod. NOTICE: More than 10-15’ (3-4.5 m) of drill rod out of the trench increases the tendency of drill rod to bend. 2. Install drill bit to the cutting end of the drill string. 3. Put drill string in approach trench. 4. Move tractor to the approach trench and align the drilling attachment with the intended bore path. 5. Turn off engine. 6. Attach drill string to drilling attachment. CMW