Ditch Witch / Charles Machine Works RT40 — Using Drill String Guide

Drill - 98 RT40 Operator’s Manual p Drill Drill IMPORTANT: For location and description of drilling control see “Drilling attachment control” on page 27. EMERGENCY SHUTDOWN: Release drilling control and turn ignition switch to STOP. 1. Start tractor’s engine and begin clockwise (forward) rotation. 2. Slowly advance tractor while maintaining clockwise rotation. NOTICE: Drilling too quickly causes bit to drift off course and may bend drill rod. After bore path is established, speed may be slightly increased. If drill rod starts to bend, stop forward movement of unit and back the unit slightly until rod straightens. Do not drill with bent rod.

If drill rod hits an obstruction, rotate drill string counterclockwise to back up slightly. Using Drill String Guide Turning shaft will kill you or crush arm or leg. Stay away. NOTICE: Keep everybody at least 10’ (3 m) away from drill rod during operation. Do not straddle trench or drill rod while drilling. Use drill string guide to align drill string as it enters the soil. When using drill string guide, follow these guidelines: Use only approved Ditch Witch drill string guide (p/n 179-737). Stand only on the left side of the approach trench. Keep drill string guide at least 3’ (1 m) behind bit. Use drill string guide to control only the first 5’ (1.5 m) of the bore path.

After drilling 5’ (1.5 m), stop unit and remove drill string guide. Do not use drill string guide during backreaming or any time the drill string is being pulled back. CMW