Basic Troubleshooting Guide The following section details basic troubleshooting techniques that will help you to understand and determine the best course of action regarding some commonly encountered problems. PROBLEM POSSIBLE SOLUTIONS Krystal Enterprises 86 RETURN TO MENU VIBRATION: Noises or Vibration at high speeds only, or in a certain range of speeds: A certain range of speeds indicates a damaged or otherwise out-of- balance drive line, Contact the Service Dept. Only SELECT drive line shops that are qualifi ed to properly balance the multiple drive line ex- tensions used in your bus. The Krystal Service Dept. can recommend one near you.
REAR A/C BLOWER INOPERATIVE Check to make sure the FORD front A/C unit is on. If the rear A/C is still not working, call the Krystal Service Dept. MOVING CARGO PARTITION TO ADD ADDITIONAL SEATING Caution: Do Not Exceed Weight Distribution/Payload Limitations Remove seats in front of the Partition Wall and loosen all four bolts securing the wall. Then go behind the wall and remove the channel nut on the fl oor, this will allow the wall to be move back and then additional seating can be installed. Note: torque Seat Bolts to 35 ft. lbs. EXTERIOR LIGHTING E-450:
One or all exterior clearance lights inoperative, please refer to the FORD wiring schematic in the Krystal Electrical Schematic Manual F-550: Exterior running lights work off of the Krystal relay board. SLIDER WINDOWS HARD TO OPEN AND CLOSED If any of the windows start to stick during opening or closing, simply spray both side tracks with silicone spray and work the windows a few times to lubricate the tracks. This should be done approximately every three months.