Basic Troubleshooting Guide PROBLEM POSSIBLE SOLUTIONS Krystal Enterprises RETURN TO MENU 87 87 PAGING SYSTEM INOPERATIVE Check the 5 amp fuse on the circuit board above the driver. Wiring schematics and instructions for the paging system are located in this manual on page 23. NO TELEVISION RECEPTION If the TV has power, but you cannot pickup any stations, make sure VCP mode button on the P.A. System is engaged and the VCP power button is engaged. REAR VCP & TV INOPERATIVE Check to make sure all connections on the back of both units are tight. Check the fuse located at the front face of the TV, and on the backside of the VCP.
EXTERIOR SEALANTS CRACKING OR LIFTING If the exterior seams of the bus ever crack or start lifting, simply clean the area with rubbing alcohol or mineral spirits completely. After this has been done you can remove the old silicone by using a sharp knife or razor cutter. Clean the area again with the above cleaners and apply a thin bead of white exterior silicone and smooth the bead with your fi nger for a smooth appearance. REAR ELECTRIC STEP INOPERATIVE Check to make sure the step switch is turned on. This switch is located inside the cargo area on the right hand sidewall. If this will not power up the step, call the Krystal Service Dept.
The rear step should be lubricated every 30 days to ensure proper operation of the step. REAR STEREO/CD INOPERATIVE Check to make sure all connections are tight. Also remove the stereo and check the fuse located on the backside of the stereo.