hyundai — l4gc

MAIN MOVING SYSTEM 2-31 INSPECTION CAMSHAFT 1. Check the camshaft journal for wear and if the journal is seriously worn, replace the camshaft. 2. Check the cam lobe for damage and if the lobe is severely damaged or worn, replace the camshaft. L4GC047A 3. Check the cam surface for abnormal wear and damage and replace it if necessary. 4. Check the cylinder head camshaft journal for damage and if the surface is severely damaged, replace the cylinder head assembly. 5. Lightly put the camshaft on the cylinder head as shown in the illustration and after installing a dial gauge towards shaft, check the endplay. OIL SEAL 1.

Check the oil seal surface for wear and if the seal lip por- tion is worn, replace it. 2. Check the camshaft oil seal lip contact surface for partial wear and replace it if necessary. L4GC048A HLA(Hydraulic Lash Adjuster) 1. HLA I.D : 33(-0.025/-0.041) 2. How to remove noise when it heard from valve 1) Prior to engine warm-up, check that the engine oil level is normal. 2) Warm-up the engine. 3) If the valve noise is heard at engine warm-up, air- bleed the system. 4) How to air-bleed a) During remaining it for 10 minutes at 3,000 rpm and over 5 minutes at idle, check that the valve noise is heard. b) Repeat the above step(a) only once or twice.

Items Standard Limit Cam height Intake 43 42.9 Exhaust 43 42.9 Camshaft endplay 0.1 ~ 0.2mm