MAIN MOVING SYSTEM 2-32 5) If the valve noise is still heard after following the above step 4), replace the hydraulic lash adjuster(HLA) which makes noise. 6) If the valve noise is heard after replacing parts, neces sarily repeat the above step 4). 7) After air-bleeding the system and replacing parts to remove noise, if the valve noise is re-heard 2-3 days after, it might be affected from defective HLA, so re place the defective HLA. A NOTE In case of the vehicle with HLA, when initially starting the engine, it is normal if valve noise is momentarily heard. B L4GC022A CAUTION 1) Because HAL is precision parts, take care not to come foreign materials such as a dust from outside.
2) Do not disassemble HLA. 3) When cleaning HLA, use clean diesel oil. 4) Take care not to make scratches and sharp edges to O.D of HLA. 5) With HLA filled with engine oil, grasp A and press B by hand as shown in the illustration, if the HLA is moving, replace the HLA. 3. Loosen the center cover bolt and remove the center cover. 4. Remove the oil filler cap. L4GC045A 5. Remove the timing belt upper cover.