MAIN MOVING SYSTEM 2-36 2) Using the special tool(09222-2D000), press the valve liter downward and install the stopper between the cam shaft and valve lifter. Stopper Pliers (09222 - 2D000) L4GC057A 3) Remove the adjusting shim using a small screwdriver and a magnet. Stopper Magnet L4GC058A 4) Using a micrometer, measure thickness of the removed shim. L4GC059A 5) Calculate thickness of new shim to be valve gap within the specified value. T: Thickness of removed shim A: Measured valve gap N: Thickness of new shim Intake : N=T+(A-0.20mm) Exhaust : N=T+(A-0.28mm) NOTE There are 20 shims up to 2.0mm at intervals of 0.04mm.