hyundai — l4gc

CYLINDER HEAD ASSEMBLY 2-72 INSPECTION CYLINDER HEAD 1. Check the cylinder head for crack, damage and leak. 2. Clean out fur, adhesive and accumulated carbon and after cleaning the oil passage, bleed the passage with com- pressed air to check it for clogging. 3. Using a square, check the cylinder head gasket for flat- ness from A and B directions shown in the illustration. If any flatness is out of the limit, replace the cylinder head or slightly cut the cylinder head gasket surface. L4GC112A VALVE 1. Clean the valve with a wire brush. 2. Check each valve for wear and damage and inspect the head and stem for torsion. If the stem end A is cave or worn, trim it. At this time, trim it least.

Also, trim the valve surface. If the margin is less than the limit, replace the valve. Valve margin L4GC113A Margin L4GC114A Flatness of cylinder head gasket surface Standard 0.03mm or less Limit 0.06mm Standard Intake 1.15mm Exhaust 1.35mm Limit Intake 0.8mm Exhaust 1.0mm