hyundai — l4gc

CYLINDER HEAD ASSEMBLY 2-73 VALVE SPRING 1. Measure free height of the valve spring and replace the spring if the measured value exceeds the limit. 2. Using a square, measure squareness of each spring and replace it if the measured value is out of squareness excessively. Valve spring L4GC115A 3. Measure the clearance between the valve stem and guide and if the measured value exceeds the limit, replace the valve guide with the following over size parts. Valve stem and guide clearance L4GC116A VALVE SEAT CORRECTION Check the valve seat for overheat and inspect contact with valve surface. Correct or replace it if necessary.

When correcting, check the valve guide for wear, if it is worn, replace the guide and correct the seat ring. Using a grinder or a cutter, correct the valve seat to make the seat contact width to the standard. When correcting the exhaust valve seat, must use the valve seat voce and pilot, after correcting, must apply a light coat of compound to the valve and valve seat. Cutter Pilot 1.3~1.7mm 1.1~1.5mm L4GC117A Standard Free height 48.86mm Installed load 18.3kg / 39mm Compressed load 40.0kg / 30.5mm Out-of-squareness 1.5° or less Limit Free height -1.0mm Out-of-squareness 3 ° Standard Intake 0.02 ~ 0.05mm Exhaust 0.035 ~ 0.065mm Limit Intake 0.1mm Exhaust 0.13mm