CYLINDER HEAD ASSEMBLY 2-75 VALVE GUIDE REPLACEMENT Because the valve guide is press-fitted, replace the valve guide as the following procedures using a valve guide installer or proper tool. 1. Remove the valve guide pressed toward cylinder block us- ing a push rod of valve guide installer. 2. Cut the valve guide insert bore of the cylinder head to the valve guide oversize. 09221-3F100A 3. Press-fit the valve guide using a valve guide installer or proper tool. When using a valve guide installer, Use a valve guide installer to press-fit the valve guide to the specified height. 09221-3F100B L4GC119A 4. When installing, start from top of valve guide cylinder head.
Be sure that the intake valve guide is not same size with the exhaust valve guide. (Intake valve guide : 46.0mm, ex- haust valve guide : 54.5mm) 5. After installing the valve guide, insert a new valve and check for perturbation. 6. When replacing the valve guide, check the valve for con- tact and correct the valve seat if necessary. Valve guide oversize Size Size mark Cylinder head bore size 0.05 OS 5 11.05 ~ 11.068mm 0.25 OS 25 11.25 ~ 11.268mm 0.50 OS 50 11.50 ~ 11.518mm