Maintenance—After 100 Hours Change Engine Break-In Oil and Filter 1. Run engine to warm oil. Stop engine. 2. Remove cap screws and remove oil pan access cover (located below engine). 3. Remove drain plug or open drain valve, if equipped, and allow oil to drain into a container. Dispose of waste oil properly. T117875B —UN—03NOV98 4. Install drain plug. 5. Remove oil filter (A). 6. Apply thin film of oil to gasket of new filter. 7. Install new filter. Turn filter clockwise by hand until gasket touches mounting surface. A—Oil Filter 8. Tighten 1/2 turn more. 10. Run engine for 2 minutes and then stop engine. Check for leaks around filter and drain plug. Tighten enough only to stop leaks. 9.
Fill engine with oil. See Diesel Engine Oil. (Section 3-1.). Specification Engine Oil (Including Filter)—Capacity................................................14 L (15 qt) Approximate 11. Check oil level. HG31779,000008C -19-28MAY02-1/1 3-5-1 070813 PN=100