Maintenance—Every 250 Hours Drain Final Fuel Filter Sediment 1. Loosen drain valve (A). Drain liquid for several seconds or until water and sediment is removed. 2. Tighten drain valve. 3. Bleed fuel system. See Replace Final Fuel Filter. (Section 3-7.) T117912B —UN—02NOV98 A—Drain Valve CED,OUO1032,1173 -19-03SEP02-1/1 Check Final Drives Oil Level 1. Park machine on a level surface and turn engine off. 2. Remove oil level and filler plug (A). Oil MUST be within 13 mm (0.5 in.) of bottom of filler hole. T117889B —UN—03NOV98 IMPORTANT: Avoid overheating and damage to components. Do not overfill final drives. 3. Add oil if needed. See Final Drive and Winch Oil. (Section 3-1.) 4. Install plug.
Right Side Shown A—Filler Plug CED,OUO1032,1034 -19-05FEB13-1/1 Change Engine Oil and Filter (450H, 550H Earlier Machines and All 650H Machines) 1. Run engine to warm oil. Stop engine. 2. Remove cap screws and remove oil pan access cover (located below engine). T117875B —UN—03NOV98 3. Remove drain plug or open drain valve, if equipped, and allow oil to drain into a container. Dispose of waste oil properly. 4. Install drain plug. 5. Remove oil filter (A). 6. Apply thin film of oil to gasket of new filter. 7. Install new filter. Turn filter clockwise by hand until gasket touches mounting surface. A—Oil Filter 8. Tighten 1/2 turn more. 10. Run engine for 2 minutes and then stop engine.
Check for leaks around filter and drain plug. Tighten enough only to stop leaks. 9. Fill engine with oil. See Diesel Engine Oil. (Section 3-1.) 11. Check oil level. Specification Engine Oil (Including Filter)—Capacity................................................14 L (15 qt) Approximate HG31779,00000F8 -19-11SEP02-1/1 3-6-1 070813 PN=101