John Deere 450H, 550H, 650H — Check Coolant Conditioner in Radiator

Maintenance—Every 500 Hours Replace Primary Fuel Filter 1. Thoroughly clean primary fuel filter and water separator assembly and surrounding area. 2. Connect a drain line (A) to filter drain adapters and drain all fuel from filters. T118016B —UN—11NOV98 3. Firmly grasp the retaining ring and rotate it counterclockwise 1/4 turn. Remove ring with filter element (B). 4. Inspect filter mounting base for cleanliness. Clean as required. 5. Remove water separator bowl (C). Drain and clean separator bowl. Dry with compressed air. 6. Install water separator bowl onto new filter element. Tighten securely. A—Drain Line B—Filter Element C—Separator Bowl D—Air Bleed Vent Screw NOTE:

The fuel filter must be indexed properly and the key on canister must be oriented in slot of mounting base for correct installation. 9. Install retaining ring onto mounting base and tighten about 1/3 turn until ring “snaps” into the detent. DO NOT overtighten the retaining ring. 7. Thoroughly inspect filter base seal ring. Replace as needed. 10. Open air bleed vent screw (D) two full turns by hand. 8. Install new filter element onto mounting base and position element using a slight rocking motion. Be sure element is properly indexed on mounting base. CED,OUO1032,1135 -19-04NOV98-1/2 11.

Pump the hand primer (C) on fuel filter until a noticeable amount of fuel and air comes out of vent opening. Continue pumping and close vent screw when fuel starts to flow. 12. Pump the hand primer several times until resistance is felt. Continue pumping and open air bleed vent screw again. T118231B —UN—11NOV98 13. Close air bleed vent screw and pump the hand primer several times until resistance is felt again. C—Hand Primer CED,OUO1032,1135 -19-04NOV98-2/2 3-7-3 070813 PN=104