John Deere 450H, 550H, 650H — Replace Primary Fuel Filter

Maintenance—Every 500 Hours Replace Final Fuel Filter 1. Turn retaining ring (A) counterclockwise and remove filter element (B). Allow sediment to drain into a container. NOTE: Dispose of waste properly. T117912C —UN—11NOV98 2. Remove fuel drain knob (C) from filter element and install on new filter. 3. Clean filter base (D). NOTE: Do not attempt to turn filter element into base. 4. Install new fuel element by aligning vertical locators (F) into slots (E) on filter base. Push filter element up firmly until filter snaps against base. 5. Turn retaining ring clockwise into filter base until retaining ring clicks tightly into place. 6. Loosen bleed screw (G) by turning knob counterclockwise.

T7896AJ —UN—25NOV92 7. Operate primer lever (H) until fuel flow from bleed screw is free of air bubbles. NOTE: If there is no fuel flow, push primer lever up and turn crankshaft using start motor to reposition camshaft. Repeat step 6. 8. Tighten bleed screw. 9. Push primer lever up as far as possible. A—Retaining Ring B—Filter C—Drain Knob D—Filter Base E—Slots F—Vertical Locators G—Bleed Screw H—Primer Lever T118083B —UN—11NOV98 CED,OUO1032,1124 -19-28AUG02-1/1 3-7-2 070813 PN=103