Miscellaneous—Machine Cleaning Dusty Primary Element IMPORTANT: A damaged or dirty element may cause engine damage. Install new element: If the element shows damage and needs to be replaced. If element is visibly dirty and will not clean. After 1000 hours service or annually. T90684 —UN—10NOV88 DO NOT clean a secondary element. Install a new element carefully centering it in the canister. 1. Tap element with the palm of your hand, NOT ON A HARD SURFACE. T47764 —UN—09NOV88 CAUTION: Prevent possible injury from flying chips. Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes.
Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. 2. If this does not remove dust, use compressed air under 210 kPa (2.1 bar) (30 psi). 3. Direct air up and down the pleats from inside to outside. Be careful not to make a break in the element. NOTE: Air restriction indicator will not signal correctly if an element has a break or is not correctly sealed in air cleaner housing. Throw away element that has the slightest damage. If gasket is broken or missing, install a new element. TX03679,00017E3 -19-31MAY01-1/1 Precautions for Alternator and Regulator When batteries are connected, follow these rules: 5.
Do not disconnect or connect any alternator or regulator wires while batteries are connected or while alternator is operating. 1. Disconnect negative (–) battery cable when you work on or near alternator or regulator. 2. DO NOT TRY TO POLARIZE ALTERNATOR OR REGULATOR. 6. Connect batteries or a booster battery in the correct polarity (positive [+] to positive [+] and negative to negative [–]). 3. Be sure alternator wires are correctly connected BEFORE you connect batteries. 7. Do not disconnect the batteries when engine is running and alternator is charging. 4. Do not ground alternator output terminal. 8. Disconnect battery cables before connecting battery charger to the batteries.
T82,EXMA,I -19-19SEP08-1/1 4-1-4 070813 PN=120