John Deere 450H, 550H, 650H — Cleaning Dusty Primary Element

Miscellaneous—Machine Do Not Service or Adjust Injection Nozzles or Injection Pump Do not service an injection pump that is not operating correctly. See your authorized injection pump service center. If injection nozzles are not working correctly or are dirty, the engine will not run normally. See your authorized dealer for service. Changing the injection pump in any way not approved by the manufacturer will end the warranty. See your copy of the John Deere warranty on this machine.

TX,90,FF3116 -19-03NOV08-1/1 C-Frame Ball / Blade Socket Joint Adjustment 7 5 3 4 2 T158731 —UN—23AUG02 6 T158731 1 1— Cap Screw (6 used) 2— Socket Retainers ( 2 used) 3— Shims (12 included) 4— Socket 5— Lubrication Fitting 6— Washer (6 used) 7— Blade 1. Park machine on level surface. Lower blade to ground. 2. Remove cap screws (1) from socket retainers (2). Remove shims (3). 5. Install ball socket retainers. Tighten cap screws to specification. Specification Socket Retainer Cap Screws—Torque......................................................... 350 N·m (255 lb-ft) 3. Install ball socket retainers without shims. Measure gap, remove ball socket retainers. 4.

Install enough shims to fill gap, plus one extra shim. OUT3019,000035F -19-22AUG02-1/1 4-1-3 070813 PN=119