Miscellaneous—Machine Checking Track Shoe Cap Screw Torque Track shoe bolt torque should be periodically checked. If the cap screws do not meet the minimum torque specifications, remove the shoes and clean the mating surfaces of the shoes and links before tightening the bolts. Specification 450H and 550H Track Shoe Minimum Checking—Torque...................................... 305 ± 14 N·m (225 ± 10 lb-ft) 650H Track Shoe Minimum Checking—Torque...................................... 380 ± 14 N·m (280 ± 10 lb-ft) T6009AN —UN—09FEB89 If unit is operated with loose track shoes, the cap screw holes in the shoes and links will wallow out and it may be difficult to keep the track shoes tight.
Loose shoes can also cause hardware failure and loss of track shoes. Install all track shoe nuts with rounded edges against the link and chamfered edges away from the link. Be sure nut is properly positioned in the link so there is full contact area between the nut and the link. T6794AM —UN—23FEB89 A—Rounded edge B—Chamfered edge TX,90,FF1972 -19-24APR99-1/2 IMPORTANT: Tighten cap screws to torque specification using a criss-cross pattern. Then repeat torque pattern again. Tighten cap screws using torque-turn torque method. Track Shoes—Specification 450H and 550H Track Shoe Cap Screw (9/16 in.)—Torque.......................................................
88 N·m (65 lb-ft) Second Pass—Additional 1/3 (120° ) turn 650H Track Shoe Cap Screw (5/8 in.)—Torque................................. 163 N·m (120 lb-ft) Second Pass—Additional 1/3 (120° ) turn 450H and 550H Master Split Link Cap Screw (9/16 in.)—Torque.............................................. 88 N·m (65 lb-ft) Second Pass—Additional 1/3 (120°) turn 650H Master Split Link Cap Screw (5/8 in.)—Torque................................................... 163 N·m (120 lb-ft) Second Pass—Additional 1/2 (180°) turn T6352AH —UN—23FEB89 NOTE: Replacement hardware should be lubricated and tightened to above specification.
TX,90,FF1972 -19-24APR99-2/2 Hardware Torque Specifications Check cap screws and nuts to be sure they are tight. If hardware is loose, tighten to torque shown on the following charts unless a special torque is specified. T82,SKMA,AT -19-01AUG94-1/1 4-1-21 070813 PN=137