Miscellaneous—Machine Checking Neutral Start System CAUTION: Avoid possible injury or death. Be sure all people are away from machine when neutral start checks are performed. 1. Move FNR lever to N. T118001B —UN—11NOV98 2. Move park lock lever to down (unlocked) position (A). 3. Turn key switch to “Start” position. Starter must not engage. If engine starts, see your authorized dealer. 4. Move park lock lever to up (locked) position (B). 5. Turn key switch to “Start” position. Starter should engage. If engine does not start, see your authorized dealer. 6. Move FNR lever to F or R. 7. Turn key switch to “Start” position. Starter must not engage. T118007C —UN—14JAN99 8. Move FNR lever to N. 9.
Turn key switch to “Start” position. Starter should engage. If starter does not engage, see your authorized dealer. A—Unlocked Position B—Locked Position CED,OUO1032,788 -19-07OCT98-1/1 Keep ROPS Installed Properly Make certain all parts are reinstalled correctly if the roll-over protective structure (ROPS) is loosened or removed for any reason. Tighten mounting bolts (A) to proper torque. Specification ROPS Mounting Bolts—Torque.............................................................
624 N·m (460 lb-ft) T117812B —UN—20OCT98 The protection offered by the ROPS will be impaired if the ROPS is subjected to structural damage, is involved in an overturn incident, or is in any way altered by welding, bending, drilling, or cutting. A damaged ROPS should be replaced, not reused. Front ROPS Mounting Bolt A—Bolts T117813B —UN—20OCT98 Rear ROPS Mounting Bolt TX,90,RB48 -19-03DEC97-1/1 4-1-20 070813 PN=136